One camera will be shown in the main section with all cameras shown across the bottom. Once the configuration is finished the Camera Companion should go to a live view of all cameras.Depending on the number of cameras this step could take several minutes. The wizard will now configure the cameras to access the share using the credentials created earlier.Once the storage configuration is finished the software will display all cameras configured for this share.Doing this manually could take 5-10 minutes or more per camera. The Camera Companion software will now configure a user and set a quota for each camera in the site. This is the part of the setup automated by the software.Select the "Recordings" share and click Next.The username will be "admin" and the password will be "password" unless it was changed in step 6. Enter the username and password for the TeraStation.Click the Connect Network Share button.
If not all the cameras are detected, check to make sure that all cameras have power and are connected to the network. The wizard should locate all attached cameras.The first screen should tell you to make sure all your cameras are attached to the network and powered up.Name the site and create a password for the site.Click Get Started to begin creation of a new camera site.Note: If the system running Axis Camera Companion has internet access, you will be asked to create an account with Axis. Note: Repeat steps 8-9 for each camera that will be used in this setup. Enter the correct IP address for the camera.Right-click the camera and click Assign IP Address.Once the wizard finishes you can close the browser window. We're leaving this one at the default for demonstration purposes. It is recommended that the default password be changed at this time to a more secure one. The default administrator username is "admin" and the default password is "password".
0 kommentar(er)
